cpuminer with this JSON configuration: { "api-bind" : "127.0.0.1:4048", "url" : "stratum+tcp://yespowerR16.na.mine.zpool.ca:6534", "user" : "D7qgtgw6CibcY4SGnFNoNmcYiJyMCs7P4o", "pass" : "c=DG

To run `cpuminer` with the provided .json config file, you should follow these steps: 1. First, you must ensure that you have the `cpuminer` package installed on your device. If not, install it based on the specific instructions for your operating system. 2. Next, you need to save your JSON configuration to a file. This can be done by copying the provided config and pasting it in a text editor such as Notepad. After pasting, save the file with a `.json` extension, for instance, `config.json`. 3. After saving the file, open your terminal or command prompt. Navigate to the directory where the `cpuminer` package and your `config.json` file are located. 4. Start `cpuminer` with your configuration file. The command for this might vary based on your version of `cpuminer`, but generally, it should be something like: ``` ./cpuminer --config=config.json ``` This command assumes `cpuminer` and `config.json` are in the same directory. Run the command and `cpuminer` will begin to work with your specified configuration. You may need to adjust `./cpuminer` based on your particular setup. For example, it might be `./minerd` instead of `./cpuminer`. Remember to replace `config.json` with the actual path to your config file if it's not in the same directory as `cpuminer`. If you encounter any issues during this process, check the error messages, ensure that your JSON is properly formatted, and that your mining parameters are correct.

The command to run cpuminer with the above configuration is: ./cpuminer -o stratum+tcp://yespowerR16.na.mine.zpool.ca:6534 -u D7qgtgw6CibcY4SGnFNoNmcYiJyMCs7P4o -p c=DGB --api-bind 127.0.0.1:4048 --algo yespowerr16 --threads 0 -- cpu-priority 0 --cpu-affinity -1 --benchmark 0 --debug 0 --protocol 0 --quiet 0